local hard disk boot after installation

[Michał Dwużnik]

2011/12/29 Thomas Lange <lange at informatik.uni-koeln.de>:
>>>>>> On Thu, 29 Dec 2011 09:44:31 +0100, Michał Dwużnik <michal.dwuznik at gmail.com> said:
>
>    > After the installation I would like to make FAI to boot the local hard
>    > disk on _server_ side, not touching the (presumably quite remote) host
>
>    > I mean -> host is initially setup for PXE boot, FAI takes over the
>    > installation process, finishes quite ok with minor warnings
>    > How should I proceed to make FAIserver consider this machine as, let's
>    > say, 'installed correctly' so it can still be setup for PXE boot, BUT
>    > receive PXE config which effectively boots the local hard disk.
> This is normally done by fai.

The keyword happened to be 'normally'. After some changes it did work

Thanks a lot.

M.

PS:Having set up 'two architecture boot' according to
http://fai-project.org/fai-guide/ar01s09.html#_anchor_id_archcross_xreflabel_archcross_how_to_install_i386_systems_from_an_amd64_system
nfsroot-i386 is set up corretly, though the entries in <HEXIP> file in
tftp are still 'amd64'. Manual change to '486'
in kernel and initrd makes installation flawless. Any idea where did I err?