HDD Configuration

[Marco Hofmann]

On Wed, 2002-05-29 at 17:48, Bruce Edge wrote:
> To troubleshoot disk problems, I change the 1st line of class/S07disk.pl from:
> #! /usr/bin/perl
> to:
> #! /usr/bin/perl -d
> 
> This way, you drop into the perl debugger and you can single step the disk detection process.
> 
> -Bruce.
> 

Thanks for that hint certainly it's useful the next time. But in this
case it was a matter of hardware failure. Two of my clients in the
dev-area were kaput. I replaced them now FAI works fine!

Thanks!

--
Ciao Marco

> 
> > -----Original Message-----
> > From: Marco Hofmann [mailto:mhofmann at gatrixx.com]
> > Sent: Wednesday, May 29, 2002 3:57 AM
> > To: linux-fai at uni-koeln.de
> > Subject: HDD Configuration
> > 
> > 
> > Hello,
> > 
> > I'm a FAI-Newbie with a little problem:
> > 
> > My clients stops after they print out the partition table of 
> > the disks.
> > An error followed: "no /etc/fstab found". They don't 
> > partition the disk
> > and i guess the error message is the outcome of this.
> > 
> > What am I doing wrong that no partitioning will be done? I 
> > put a DEFAULT
> > file for partitioning in /usr/local/share/fai/disk_config.
> > 
> > Ciao Marco
> > 
> > 
> > 
> > 
> > 
> 
>